Modelling and boundaries

[victorgrant]

Hello,

I am trying to generate 3D model of the proposed pavement area. I extracted all proposed contours that are referring to the pavement, edge of pavement lines as break-lines, all high and low pavement points, and basically all points that have proposed grades I have found on the pavement (like manholes and inlet boxes). One of the roads that pass near one parking lot is approx. 1 foot lower then this parking itself. The problem is that parking TIN and road TIN overlap that influences my model, which is not correct for that area. I guess I have to set up boundaries (to build boundaries from the lines that represent edge of pavement), but I didn’t find out how. When I set up boundaries (MsModelling>Boundary options> Set Boundaries), it doesn’t seem to influence on my model. It just doesn’t display TIN outside boundaries.

Any help will be apprecited.

I didn't find the right solution from the Internet.

References:
www.microsurvey.com/forum/viewtopic.php?f=3&t=935
Medical Animated Explainer

Thank you.

[annemckarther]

A client presentation should include relevant touchpoints to show how the logo appears when seen by potential customers. It’s a little like when you’re stuck in a rut – it can help to step back, to look at the bigger picture, to see where you are and what you’re surrounded by.